BATH BUDDY BATHMATE, Инструкция

Страница: 5 / 20

Putting the Cushion into the bath
1
. With the cushion deflated, place into the
bath, making sure the sucker tabs are each
pointing away from the cushion. Care
should be taken not to twist, bend or
crush the hose during this operation.
IMPORTANT Each sucker must be securely
fastened to the bath surface, to check this pull
gently on each sucker to establish adhesion.
2. Switch on the power at the mains supply,
checking the green light on the blower unit
is illuminated.
3. Take the hand control unit in either hand
and gently depress the up button until the
cushion is fully inflated (see diagram A).
The machine is designed to stop once the
correct pressure has been achieved.
Releasing the button at any time will stop
inflation (see note 1 in notes section).
IMPORTANT - The up button should be
depressed until the blower unit stops inflating
automatically, failure to do so will cause the
cushion to be under inflated.
Before use check for air leaks from the cushion
and hose. Any air leaks will be visible in the form
of air bubbles emitted from the hose or cushion.
If any air leaks are present discontinue use and
contact your supplier.
A
3
Setting Up
The appliance must be set up in the bathroom with a minimum
distance of 60cm in all directions away from the bathtub or shower
Any existing bathroom socket must be protected by an isolation
transformer or a residual current device (RCD) with 30 mA. If this
is not fitted, then the compressor must be plugged in outside the
bathroom.
To ensure the cushion sticks to the bath surface correctly, both
suckers and surface should be clean and free from deposits left
by cleansers.