Batco 1300 P Series, Руководство по эксплуатации

Страница: 9 / 44

BATCO - T
OP
D
RIVE
F
IELD
L
OADER
2. S
AFETY
F
IRST
1300 P, 1500 P S
ERIES
2.2. T
RANSPORT AND
P
LACEMENT
S
AFETY
P1512121 7
• Follow good shop practices:
• keep service area clean and dry
• be sure electrical outlets and tools are properly
grounded
• use adequate light for the job at hand
• Think SAFETY! Work SAFELY!
2.2. TRANSPORT AND PLACEMENT SAFETY
• Be sure that conveyor is empty before raising or lowering.
• Check with local authorities regarding transport on public roads. Obey all
applicable laws and regulations.
• Always travel at a safe speed, never exceeding
20 mph (32 km/h). Reduce speed on rough
surfaces. Use caution when turning corners or
meeting traffic.
• Make sure the SMV (slow moving vehicle)
emblem and all the lights and reflectors that
are required by local authorities are in place,
are clean, and can be seen by all over-taking
and oncoming traffic. Always use hazard-warn-
ing flashers on tractor/towing vehicle when
transporting unless prohibited by law.
• Do not allow riders on the machine, towing
vehicle, tractor, or skid steer during transport.
• Stay away from overhead obstructions and
power lines when operating and transporting.
Electrocution can occur without direct contact.
• Fully lower conveyor before transporting, and
only raise when next to storage facility.
• Review the work safety area diagram before
starting work.
• Attach a conveyor to towing vehicle with a pin
and retainer. Always attach safety chain(s).
• Chock front and rear conveyor and tractor
wheels before operating.
• Do not raise the intake end above drawbar,
conveyor upending may occur.
• Be familiar with the machine transport hazard
area. If anyone enters the hazard area, shut
down the machines immediately. Clear the
area before restarting.
• Do not transport conveyor on slopes greater than 20°.
• When lowering the auger the track shoe may become stuck; if this happens,
do not continue to turn the winch handle counter-clockwise because it will dis-
engage the brake mechanism and create an unsafe condition. Too much
slack in the cable may also cause the conveyor to drop suddenly.