Batco 1300 P Series, Руководство по эксплуатации

Страница: 34 / 44

8. M
AINTENANCE
BATCO - T
OP
D
RIVE
F
IELD
L
OADER
8.3. S
ERVICE
& M
AINTENANCE
P
ROCEDURES
1300 P, 1500 P S
ERIES
32 P1512121
Figure 8.2 Hopper Roller
T
RANSITION
R
OLLERS
Note: The top transition roller should be the only one requiring adjustment. Only in
extreme cases does the bottom transition roller require adjustment (Figure 8.3).
1. Loosen bearing bolts and jam nut (if equipped).
2. Rotate adjustment bolt 1/2 turn on the side the belt is running towards.
3. Restart conveyor and run empty for 1 minute.
4. Stop conveyor, remove ignition key or lock out power source.
5. If belt centered, then move to next step below; otherwise, repeat from step 2.
6. Tighten bearing bolts and jam nut (if required).
Figure 8.3 Field Loader Transition Rollers
H
EX
R
OLLERS
/ W
EATHER
G
UARDS
1. Start at hopper or last adjusted roller and check that belt is centered on each
belt return bracket.
2. If belt is not centered, adjust bracket toward hopper slightly on side belt is
tracking toward.
3. Adjust wear blocks if unit has weather protectors (see Figure 8.4).
Note: Wear blocks are located on every second weather protector bracket.
4. Restart conveyor and run empty for 1 minute.
5. Stop conveyor, remove ignition key or lock out power source.
6. If belt has not centered repeat from step 2.
HOPPER ROLLER