Batco 1300 P Series, Руководство по эксплуатации

Страница: 35 / 44

BATCO - T
OP
D
RIVE
F
IELD
L
OADER
8. M
AINTENANCE
1300 P, 1500 P S
ERIES
8.3. S
ERVICE
& M
AINTENANCE
P
ROCEDURES
P1512121 33
Figure 8.4 Weather Guard Guide Block
8.3.6. C
ONVEYOR
B
ELT
R
EPLACEMENT
1. Rotate the
belting until
the lacing is
by the hopper
or easily
accessible.
2. Move the
tension roller
to its loosest
position.
3. Pull all the
slack to the
lacing area.
4. Remove the
lacing pin (see
Figure 8.6).
5. Attach one end of the replacement belt to the belt end being removed,
closest to the hopper.
Important: Ensure that the belt is installed as shown in Figure 8.6. Note the direction of belt
travel and square and trimmed edge positions.
6. Pull the old belt out and the new belt will be threaded into place.
7. Disconnect the old belt.
8. Reattach
conveyor belt ends together. If required, use a ratchet strap
clamped to both ends of belt to cinch belting ends together.
9. Install lacing pin and crimp retainer clips onto each end of the lacing pin.
10. Remove ratchet strap and tighten conveyor belt. (See Section 8.3.3.)
11. Check and set belting alignment. (See Section 8.3.3. and 8.3.5.)
Figure 8.5 Belt Path