19
English
Problem
Possible cause
Solution
3.
The actual
cutting depth is
less than the
set cutting
depth.
There is a build-up of saw-
dust blocking the base plate.
Shake the saw to remove the
sawdust.
Connect a dust extractor (see chapter
“Connecting the dust extractor”).
4.
The fitted tool
slips.
The fitted tool is not secure
enough.
Remove the fitted tool and put it back
in (see chapter “Inserting and chang-
ing the fitted tool”).
5.
The fitted tool
doesn’t cut in a
straight line.
The fitted tool is dull.
Mount a new, sharp fitted tool.
The fitted tool is not properly
mounted.
Check whether the fitted tool has
been properly mounted.
The product is not being
guided properly.
Use the cutting line guide.
6.
Product does
not reach its
full power.
Vents are blocked.
Clean the vents.
7.
Unsatisfactory
result.
The fitted tool is worn out.
Replace it with a new, sharp fitted
tool.
The fitted tool is not suitable
for the task.
Use a suitable fitted tool.
8.
Excessive
vibration and
noise.
The fitted tool is blunt or
damaged.
Replace it with a new, sharp fitted
tool.
Screws/nuts are loose.
Tighten the screws/nuts again.
9.
The product
overheats.
Clogged vents.
Clean the vents.
Product is overloaded.
Only use the product as intended.
10.
Product stops
suddenly.
Product is overloaded.
Remove the product from the work
piece and switch it on again.
11.
Too much
sparking or
motor runs
irregularly.
Dirt in motor or worn carbon
brushes.
Every individual part is an important
component of the double safety insu-
lation and must not be repaired by the
user. Have it checked by a
professional.
12. Technical data
Nominal voltage/frequency:
. . . . . . . . . . . . . . 230 – 240 V ~, 50 Hz
Nominal output: . . . . . . . . . . . . . 710 W
Protection class: . . . . . . . . . . . . . . . . II
Idle speed n
0
/rated speed n: . . . 5300 min
-1
Cutting depth: . . . . . . . . . . .
max
. 26 mm
Weight: . . . . . . . . . . . . . approx. 2.6 kg
Multi Material (MM) saw blade
Dimensions: . . . . . .Ø 89 × Ø 10 × 1.4 mm
Number of teeth/segments: . . . . . . . 24 T
Material:. . . . . . . . Wood(HS/HW),plastic
Max. speed permitted: . . . n
max
7000 min
-1
Diamond cutting disc
Dimensions: . . . . . .Ø 89 × Ø 10 × 2.0 mm
Material:. . . . Tile, marble, granite, concrete
Max. speed permitted: . . . . . . 8000 min
-1
Top operating speed: . . . . . . . . . 37 m/s
Laser
Class: . . . . . . . . . . . . . . . . . . . . . . 2
Standard: . . . . . . . . . . EN 60825-1:2014
Wavelength λ: . . . . . . . . . . . . . 650 nm
Output energy P
0
: . . . . . . . . . . . ≤ 1 mW
Battery: . . . . . . . 1 × 3 V
⎓
, Li-Ion, CR2032
7063051-Thor-Compact-Ma-1804-30.indb 19
04-06-18 11:55
