NOTE: always turn unit OFF when not in use
DUAL POWER UNIT
# R811-0010
Remote Control
Receiver with Fobs
Remote Key Fobs
Hydraulic Fluid (quart)
# R812-0016
# Y354-0001
# R283-0002
Solar Controller
Connect to Solar Panel
Connected
POWER UNIT
SUB-ASSEMBLY
#
H603-0015
Padlock
not included
SOLAR PANEL
#
R281-0004
ENCLOSURE
#
C243-0004
pre-wired
with wiring
harness
CONTROL PANEL
ASSEMBLY
#
R815-0011
Please order replacement parts by PART NO. and DESCRIPTION
USE ONLY BASTA BOATLIFTS
BIODEGRADABLE HYDRAULIC FLUID
OIL INJECTED INTO THE SKIN FROM HIGH
PRESSURE LEAKS IN HYDRAULIC SYSTEMS
CAN CAUSE SEVERE INJURY. MOST DAMAGE
OCCURS DURING THE FIRST FEW HOURS.
SEEK MEDICAL ATTENTION IMMEDIATELY.
SURGICAL REMOVAL OF OIL MAY BE
NECESSARY.
one
inch
only add fluid with lift
in DOWN position
Ensure each Quick Coupler is
completely seated and
tight
with
no gap at the connection joint.
Connection must be
tight
to open internal
check valve and allow fluid to flow. USE PLIERS
DO NOT SUBMERSE
Keep inside dry
NO GAP!
Prevent unauthorized use -
KEEP BOX LOCKED
hydraulic fluid level shown
with lift in DOWN position
COMPLETE POWER UNIT
#
H653-0015
power
switch
POSITIVE BATTERY
CABLE (RED)
#
R711-1010
NEGATIVE BATTERY
CABLE (BLACK)
#
R711-1005
HOSE ASSEMBLIES
#
H123-0001
remote
receiver
up/down
switch
LIFT2
MALE QUICK COUPLER
#
H700-0020
FEMALE QUICK COUPLER
#
H700-0019
solar
controller
1.
The Hydraulic Power Unit will arrive fully assembled. Make sure
all the connections are snug to prevent leaks or loss of power to
the unit.
2.
Install a Group 31 Deep Discharge AGM battery as shown. Be
sure to connect the red battery cable to the positive terminal and
the black battery cable to the negative terminal.
NOTE:
Ensure the battery cables are correctly connected and their
terminals are tight (use a wrench).
3.
Slide each hydraulic hose assembly through the access hole in
the side of the fiberglass enclosure and attach the end to its
corresponding quick couplers.
4.
Plug the cable from the solar panel into the connector on the
wiring harness that comes from the solar controller as shown
above left.
5.
Read the Operating Instructions in the Owner’s Manual.
6.
Test the lift on dry ground using the UP/DOWN switch and the
key fob transmitters.
7.
Inspect the system for leaks.
up/down
switch
LIFT1
LIFT 1
LIFT 2
DUAL POWER UNIT
6
7
BATTERY SAFETY IS IMPORTANT
Follow all battery manufacturer’s
warnings and safety information.
