Basta Boatlifts Over-Center BM4050SP, Руководство пользователя

Страница: 4 / 12

ASSEMBLY INSTRUCTIONS Cont.
4
NOTE: always turn unit OFF when not in use
13
7
9
8
12
6
14
5. Test the lift on dry ground using the Up/Down Switch
(#9) and the Key Fob Transmitters. Inspect the
system for leaks.
1. The Hydraulic Pump will arrive fully assembled. Make
sure all the connections are snug to prevent leaks or
loss of power to the unit.
2. Install a Group 27 Marine Grade Battery as shown
above. Be sure to connect the Red Battery Cable (#12)
to the positive terminal and the Black Battery Cable
(#13) to the negative terminal.
NOTE: Ensure battery cables are correctly connected
3. Slide the Hydraulic Cylinder Hoses (#14) through the
access hole in the side of the White Fiberglass Box
(#10) and attach them to their corresponding
Quick Couplers (#4, #5).
and their terminals are tight (use pliers).
4. Pass the cable from the Solar Panel through the same
access hole as the hoses and plug it into the Remote
Control Unit (#7A) as indicated in the diagram at right.
one
inch
hydraulic fluid level with
lift in DOWN position
only add fluid with lift
in DOWN position
2
NO GAP!
4
5
Ensure each Quick Coupler is
completely seated and tight with
no gap at the connection joint.
Connection must be tight to open internal
check valve and allow fluid to flow. USE PLIERS
Prevent unauthorized use -
KEEP BOX LOCKED
DO NOT SUBMERSE
Keep inside dry
10
11
Padlock
not included