BASHLIN PATRIOT 76PAT, Руководство пользователя

Страница: 16 / 20

16
INSPECT ALL PATRIOT™ COMPONENTS PRIOR
TO REPLACING THE POLE ROPE.
• All hardware must be free of any signs of stress, cracks, indications
of electrical contact or extreme wear.
• The red wear indicator on the Red/White/Blue inner line should not
be visible.
• The carabiner, connector slot and connector latch should be free from
debris, open easily and close completely.
If any of the components fail the inspection, do not continue with the pole
rope replacement. The failed equipment must be removed from service.
C
A
B
1
2
1
Remove the old rope by cutting
the line, and pulling the pieces
out of the adjustor and the
connector body.
[A]
2
Remove the nylon wire tie from
the end of the factory formed
loop end and straighten the line.
3
Insert the replacement line
into the adjustor, then slide
the adjustor down to the end
termination of the pole rope.
This will keep these parts out
of the way as you work.
[B]
4
Insert the free or whip end of
the replacement pole rope into
hole #1 of the connector body,
pulling section with the factory
formed loop past the end, then
insert the whip end into hole #2
and pull the end through.
[C]
5
Match the alignment marks.
The rope should take a natural
set on the factory formed loop.
One set of marks is for the
ends, the other to position the
rope clamp.
[C]