Technical data
Input voltage/current .............................230 V/AC, 50 Hz, 500 mA
Output voltage/current ..........................5 V/DC, max. 5100 mA (total)
5 V/DC, max. 2100 mA (x1)
5 V/DC, max. 1000 mA (x3)
Operating/storage conditions ................0 to +40 ºC, 0 – 80 % RH (non-condensing)
Cable length .........................................150 cm
Dimensions (W x H x D) .......................110 x 100 x 60 mm
Weight ..................................................320 g
Operation
Always switch off the desired devices before connecting to the charger.
Make sure the household mains outlet to be connected is in accordance with
the charger’s input voltage requirements (see technical data).
Make sure that your devices meet the product’s power requirements.
For safety purpose, use the original USB cable of your device to connect to
the charger.
Make sure the connection is correct. If the product is not connected properly,
it could overheat or cause an electric shock or fire.
• The product features 4 USB ports. You can charge or operate several devices at
the same time. How to connect a single USB device is described below.
• The current output of the 2.1 A port must not exceed 2100 mA, and the current
output of each 1 A port must not exceed 1000 mA.
• Connect your devices according to the current output ratings of the ports, this
will make the charging efficient.
• (Optional) Use the silicone case:
• Wrap the excessive mains cable and put it into the silicone case.
• Pass the mains plug through the narrow slot of the silicone case.
• There are 2 holes to the narrow slot. Position the mains plug to either of the holes as
needed (as shown in the figure).
• Put the charger in the silicone case, the USB ports facing outward.
• Connect the switched-off USB device to the charger.
• Connect the mains cable to a household power outlet. The power indicator on the charger
lights up to indicate the charger is operational.
• Your USB device is now charging. Should you wish to operate the USB device, you may
turn it on now.
• Switch off the USB device before you disconnect the charger from the household power
outlet.
• Unplug the mains cable from the household power outlet after use.
• (Optional) After use, store the charger in the storage bag.
Maintenance and cleaning
• Never use aggressive or abrasive cleaning agents, rubbing alcohol or other chemical
solvents, as those can damage the housing or even affect the operation of the product.
• The product does not require any maintenance, do not disassemble it.
• Disconnect the product from the household power outlet and any connected devices before
cleaning.
• To clean the product, a dry, soft and clean cloth is sufficient. Do not apply too much pressure
to the charger’s housing to prevent scratching. You can easily remove dust using a long-
haired, soft and clean brush.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste.
At the end of its service life, dispose of the product in accordance with applicable
regulatory guidelines.
You thus fulfill your statutory obligations and contribute to the protection of the
environment.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represents the
technical status at the time of printing.
© Copyright 2016 by Conrad Electronic SE.
V2_0316_02-EST-Mkd
