Basementsaver Battery Powered Backup Sump Pumps -
www.basementsaver.com
-
Call 716.775.0206
Updated Jan 2016
2
Basementsaver BP3 Battery Backup Sump Pump
Easy Installation Instructions
BEFORE
you begin installing your pump,
Please Read ALL Instructions
.
The pumping capacity of Your BP3 pump
may vary depending upon your specific piping configuration, battery age, and battery capacity.
If You Have Questions:
If you have any questions visit
www.basementsaver.com
or
with your question
or
call 716.775.0206 for help.
Customer Support Hours Are 9am-5pm EST, Mon
– Fri (Excluding Holidays)
Ultimate backup sump pump protection for large residential / commercial basements with extremely high sump flow.
The NEW Basementsaver BP3 Battery Backup Pump design provides highly efficient and powerful emergency pumping from
a very compact unit. Our most powerful backup sump pump runs on 110V AC electricity using an inverter connected to one
or two 12V batteries, and a battery charging / maintenance system.
Basementsaver BP3 offers
higher pumping capacity
than most 1/3 HP or 1/2 HP Primary Sump Pumps.
Specifications
Physical Size:
Pump Motor:
115 VAC, 4.7 Amps, ½ HP
Pump Size: Diameter: 8" Height: 12"
Battery Charger:
1.0 AH @ 12 VDC, 0.4 Amp Load
Battery case L: 17", W: 9-1/2", H: 11"
Charger Service:
120 VAC, 60 HZ, GFCI Outlet
Pump weight: (without battery): 11 Lb
Float Switch:
Vertical Style, with mounting clamp
Total shipping weight: 35 Lbs.
High Water Alarm:
85 dBA 9VDC
2"
or 1½” PVC Discharge Capable
Battery Requirements:
12V Marine deep cycle or Sealed Lead acid, Size 27 (NOT Included)
Basementsaver BCC Optional Extra battery case is available to double pumping time at the same pumping rate
Flow Rates:
Pumping Times:
At 5 feet
3300 Gallons Per Hour
Using Marine Deep Cycle Battery/10 second cycles
At 10 feet
3000 Gallons Per Hour
At 1 minute intervals 12 Hours
Do not exceed 22 feet total lift; pumping capacity will be reduced**
At 5 minute intervals 24 Hours
At 15 minute intervals 48 Hours
Included Parts:
Submersible Pump Unit on Integrated Suction/Discharge Stand
12VDC-115VAC 1,800W Inverter
Battery Case with Cover & Cables (Battery not included)r
Discharge Pipe Kit with 4ft Flexible Hose
Vertical Switch to activate pump (pre-wired piggyback plug)
High Water Alarm
Battery Charger with Cables
Installation Instructions; safety specifications
Additional Parts & Supplies Needed:
Tools Needed:
Check valve for primary pump (existing?)
Hand saw and/or PVC cutting tool
PVC Primer and Cement (small cans) for PVC connections
Phillips and slotted screwdrivers
Teflon Tape or Pipe Sealant (Dope) for threaded connections
Utility knife, tape measure, large adjustable pliers
Deep Cycle Marine, Lead Acid, Gel, or AGM Battery (Purchase Locally!)
Next, Please Record Your BP3 Battery Backup Sump Pump Information Below:
Model No.
BP3
Serial No:
_____________________
Installation Date:
_________________
