SANIDRY CSB INSTALLER'S AND OWNER'S MANUAL
5
SaniDry CSB Installer’s & Owner’s Manual
7. Maintenance
CAUTION!
NOTE: Do not operate the unit without the proper filter or with
a less effective filter. The heat exchange coils inside the unit
could become clogged, resulting in a loss of effectiveness
and/or efficiency and may require disassembly to clean.
7.1 Air Filter
The SaniDry CSB ships with a standard MERV-11 65% 1"
pleated fabric filter and a 1/4" aluminum framed pre-filter
installed. Operating the unit with a dirty or obstructed filter will
reduce dehumidifier capacity and efficiency and may cause the
compressor to cycle on and off unnecessarily.
7.2 Cleaning & Replacement
Check filters every six months. Clean and/or replace when filters are
visibly dirty. See cleaning instructions below. For replacement filters
call your local Basement Systems dealer.
The 1/4" washable pre-filter
should not to be discarded.
Inspect the pre-filter for debris,
dirt, or other obstructions at
the same time the 1" pleated
fabric filter is checked. Wash the
1/4" pre-filter every time the 1"
pleated fabric filter is replaced. To
clean the 1/4" pre-filter, remove
filter from the unit, rinse the 1/4"
pre-filter in water with the water
flowing through the aluminum
support mesh side. Refer to
Figure 11. Allow the filter to dry
completely before reinstalling.
Reinstall the filters per the
instructions below or on the tag
located on the 1/4" pre-filter.
CAUTION!
NOTE: Failure to follow filter handling instructions may result
in improper function of the dehumidifier and cause premature
filter wear.
7.3 Remove Filters
1. Gently remove the 1/4" pre-filter by pulling on the tab
attached to the filter.
2. Gently remove the 1" pleated fabric filter by pulling it out
of the unit.
7.4 Installing Filters
1. Gently slide 1" pleated filter into filter slot. Do not force.
If resistance is felt, check alignment for obstructions or
debris inside the filter housing.
2. Gently slide 1/4" pre-filter to left of 1" pleated filter.
Do not force. If resistance is felt, check alignment for
obstructions or debris inside the filter housing.
8. Service
WARNING!
Servicing the SaniDry CSB with its high pressure refrigerant
system and high voltage circuitrypresents a health hazard which
could result in death, serious bodily injury, and/or property
damage. Only qualified service people should service this unit.
8.1 Technical Description
The SaniDry CSB uses a refrigeration system similar to an air
conditioner’s to remove heat and moisture from incoming air and
add heat to the air that is discharged. Hot, high pressure refrigerant
Figure 13: SaniDry CSB refrigeration system.
115 VAC, 60 Hz, SINGLE PHASE
BLK
BLK
WHT
WHT
GRN
GRN
YEL
RED
FAN SWITCH
DEFROST
THERMOSTAT
FAN MOTOR
COMPRESSOR
3
1
2
BLK
BLK
BL
U
ORG
S
C
R
GRN
FAN ON
FAN AUTO
DEHUMIDISTAT
RUN
CAPACITOR
115 VAC, 60 Hz, SINGLE PHASE
BLK
BLK
WHT
WHT
GRN
GRN
YEL
RED
FAN SWITCH
DEFROST
THERMOSTAT
FAN MOTOR
COMPRESSOR
3
1
2
BLK
BLK
BL
U
ORG
S
C
R
GRN
FAN ON
FAN AUTO
NEW CONTROL
RUN
CAPACITOR
Wiring Before Changes
Wiring After Changes
Figure 14: Wiring diagram.
