BAS-IP SP-03, Руководство по установке

Страница: 15 / 18

Installation and connection – 15
•
•
•
•
•
•
•
Installation and connection
This page describes how to install and connect the device.
Completness check of the product
(see page 15)
Electrical connection
(see page 15)
Mechanical mounting
(see page 16)
Connection of additional modules
(see page 18)
Completness check of the product
Before installing the monitor, be sure to check its completeness and the presence of all
components.
The kit includes:
Device 1pc
Installation manual 1pc
Installation screws 2pcs
Wall mounting bracket 1pc
Electrical connection
After verifying whether a device is complete, you can switch to the connection.
For connection you will need:
An Ethernet UTP CAT5 or higher cable connected to a network switch/router.
Power supply at + 12V, 2 amps if there is no PoE.
Wires must be brought for connecting the additional modules (optional).
Cable length recommendations
The maximum length of the UTP CAT5 cable segment should not exceed 100 meters,
according to the IEEE 802.3 standard.
