- 32 -
Mount the wall holder of the heater on the threaded bolts of the anchors. Place the
washers on the threaded bolts and tighten the wall holder with the nuts.
CAUTION!
The device may be used only in the horizontal position!
Change of the inclination
WARNING! Burn hazard!
During the operation, the heater becomes very hot!
Never change its inclination angle the heater during use!
Disconnect the device from the power supply before
introducing changes and leave it to cool down.
•
The inclination angle may be changed within the
range from 0° to 90°.
•
For this purpose, loosen both M6* bolts near the
wall holder (the figure on the right) by means of
the Allen wrench.
•
Set the desired inclination angle. Next, retighten
the loosened bolts with the Allen wrench.
CAUTION!
The inclination angle may be changed only in the way presented!
Wall holder
Anchor
Wall
