- 31 -
•
If the device is mounted in workshops or garages in which flammable or combustible
lacquers are used, keep a safe distance of at least
4 meters
from the source of
hazard.
•
If the device is installed in the areas in which spray-painting of any type is
performed, it cannot be switched on during lacquering.
•
Mount the device so that the plug is easily accessible so as to quickly disconnect
the device from the power supply if the need arises.
Installation
•
The device is designed for wall mounting. Use the supplied mounting accessories.
Perform the following actions:
Step 1:
Using 3 M6*10 bolts and 3 nuts mount the heater on the wall holder.
Step 2:
WARNING!
During the installation of the wall
holder, make sure to mount the
device as shown on the illustration
on the right, to avoid fire hazard as a
result of electronics overheating.
right
wrong
Using the holes in the wall holder mark 4 drilling places at the height of at least 180 cm.
Drill 4 holes and insert 4 supplied M6*50 anchors.
Unscrew the nuts by means of the open end wrench, then remove spring washers and
ordinary washers from threaded bolts of the anchors. The removed elements will be
used during further mounting.
M6*10 bolts
Wall holder
M6 nuts
