- 24 -
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with that of the
device (see type label).
Connect the device only in case of compliance! Take note of the security advice!
5.2 Installation and connection
•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of the device.
•
Not
at any time
should you place the device on an inflammable surface (such as: table cloth,
carpet, etc.).
•
Do not
place the unit in the vicinity of open sources of fire, electric cookers, furnaces or other
sources of heat such as e.g., in places exposed to direct sunlight. The heat can damage the
surface of the unit, as well as have a negative effect on the cooling power and increase the
consumption of energy.
•
In order to avoid compressor errors, do not tilt the unit above 45° during its placement or
transport.
•
The unit should be placed in a manner that assures the proper circulation of air in order to
guarantee the cooling properties of the unit. A minimum space of 5 cm from walls and other
objects should be maintained.
•
Do not place the unit in locations with high air humidity or high temperatures, because these
factors can damage the unit.
•
Before the first use the unit should stand for at least 2 hours before it is connected to the
power source.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the unit
directly to the wall socket; do not use any extension cords or power strips.
•
Position the device in a way so that the power plug is always accessible.
5.3 Operating
•
Remove the front casing (lifting it up).
•
Before use, clean the inside and outside of the unit with a moist, soft cloth. Dry thoroughly the unit.
•
Wash the movable condensation collector and insert it again into the unit.
•
Connect the unit to a grounded outlet.
Setting the temperature
•
The optimum temperature for drinks located on the unit can be set using the thermoregulators
located in the back of the unit.
•
Press
the
button to show the set temperature.
•
Press
the
or
button to change and save the temperature in the unit’s memory.
•
Press the
button to end the process of setting the temperature and showing the
temperatures inside the unit.
