Installation and operation
1062213
19 / 24
EN
Before Start-Up
DANGER!
Never perform the tightness test with use of open flame!
1. Perform the tightness test before the gas table-top grill start-up.
2. Make sure that the gas cylinder valve is closed.
3. Use the paintbrush to cover the gas connections with water and soap or use
tightness tester spray.
4. Finally connect the pressure to the gas hose by opening the gas cylinder valve.
The connections are tight if no soap bubbles from suds.
5. If there are leaks, check the connections, and tighten them.
6. Carry out the leak check again as described above.
7. Before use, clean the appliance and its equipment. Follow the indications in
section
6
.
'Cleaning and Maintenance'
.
Indications for the User
• Heat the grill frying pan (1061933) slowly before use, absolutely not using full
power, in order to avoid the material damage.
Never heat the frying pan
without grease!
•
Do not use the grease tray when operating the appliance with the grill
frying pan.
Otherwise the damages may occur leading even to the malfunction
of the whole appliance.
• Before using the grill grate fill the grease collection tray with small amount of
water, and slide it into the guides under the frame.
When operating the
appliance with the grill grate always use the flame cover and grease
collection tray.
• While using the grill grate do not place any foils on it or between the grate and
the flame cover as the heat accumulation may occur.
Fire hazard present!