- 32 -
•
Store the gas cylinders in the vertical position even when empty.
•
The device is designed for outdoor use only.
Fig. 4
①
Gas cylinder valve
②
Pressure controller
③
Gas hose
④
Gas cylinder
⑤
Hose breaking protection
•
Fix the appropriate pressure controller
②
to the gas cyliner
④
(fig. 4) using large
brass nut.
•
Place the hose breaking protection
⑤
between the pressure controller and the gas
hose. (as shown.)
•
Finally connect the gas hose
③
with the pressure controller
②
.
Use only connection hoses with DVGW certificate.
•
Make sure that the rubber seal is in the nut. Tighten the nut properly. Make sure
that the nut thread is left-hand.
•
Connect the gas hose to ¼“ connection on the right side of the gas table-top grill.
Use appropriate wrench.
•
Make sure that the gas hose is correctly fixed and perform the tightness test as
described in section
5.4.1
“Before start-up”
.
5.4 Operation
Before start-up
DANGER!
Never perform the tightness test with use of open flame!
•
Perform the tightness test before the gas table-top grill start-up. Make sure that the gas
cylinder valve is closed. Use the paintbrush to cover the gas connections with water
and soap or use tightness tester spray. Finally connect the pressure to the gas hose by
opening the gas cylinder valve. The connections are tight when there are no bubbles
on the soap.
⑤
