Bartscher Ice Cube Maker, Руководство по эксплуатации

Страница: 32 / 90

E E N N
The appliance is equipped with an ice-cube dispenser (18) on the front.
To take the required quantity of ice, place a glass or a suitable container under the dispenser and press the button (19) to turn on the
supply.
8.1.a ADJUSTING DISPENSED QUANTITY (Fig. 11)
IMPORTANT:
• the operations described below must be performed by a specialized technician, and only after disconnecting the appliance from the
electricity mains
• all operations that require handling of parts made of metal plate must be carried out wearing suitable gloves to prevent cuts
The appliance is provided with an electronic device for adjusting the quantity of ice dispensed each time.
To increase or decrease the dispensing time and the proportionate quantity of ice dispensed, proceed as follows:
• remove the basin (20)
• slacken off the screws (21) on the front panel using a Phillips screwdriver
• pull out the front panel from above
• turn the knob (22) on the electronic device clockwise to increase the quantity of ice dispensed whenever the button is pressed, and
anti-clockwise to reduce the quantity
8.2 MODEL WITH COLD WATER DISPENSER (Fig. 12)
The appliance is provided with a cold water dispenser located beside the ice bin.
To obtain cold water, place a glass under the outlet and gently press the button (23) to turn on the water tap. Release the button to stop
the flow of cold water.
If the appliance is already provided with a filter located on the cold water supply circuit, read the instructions on the filter label carefully and
follow the manufacturer’s recommendations regarding the replacement schedules.
9 MAINTENANCE
9.1 CLEANING THE FILTER OF WATER SUPPLY SOLENOID VALVE (Fig. 13)
All the operations described in this paragraph must be carried out only after the electric power and water supplies have
been disconnected, as described previously, by professionally qualified and authorized personnel.
At least every two months, clean the filter (24) located on the water inlet solenoid valve, proceeding as follows:
•
switch off the electric power supply by means of the switch (7 in Fig. 4), fitted during installation, and disconnect the plug of the
appliance from its socket (if any)
• shut off the water supply by turning the tap (8 in Fig. 4) fitted during installation
• unscrew the threaded ring nut (14) of the water feed hose, located at the outlet of the solenoid valve at the rear of the appliance (front
for the flush-mounting models) . For the built-in model, first remove the panel as indicated at point 5.2.a
• using a pair of pliers, remove the filter (24) from its seat without damaging the water feed pipe connector
• place the filter under a strong jet of water to remove residue, but replace the filter if it is excessively dirty
After having carried out the cleaning operations, refit the filter and hose pipe taking the necessary precautions described earlier in the
manual.
When the operations have terminated, turn on both the electricity supply and water supply.
9.2 AIR-COOLED MODELS (Fig. 14)
For air-cooled models, it is very important to keep the finned condenser and its external filter
(if any) clean.
Have the finned condenser cleaned at least once every two months by an Authorized Technical Service Centre, which can include this
operation in the scheduled maintenance programme.
The external filter (if any) must be cleaned at least once a month, as follows:
• switch off appliance and
cut off power supply with the switch (7 in Fig. 4) fitted at the installation stage
• open plastic grille
• remove filter and keep it at a distance form the appliance
• remove dust from filter by blowing with compressed air
• replace filter in its seat and close plastic grille
9.3 CLEANING AND SANITIZING OPERATIONS
A cleaning and sanitizing kit specifically designed for this appliance is available from your dealer.