- 25 -
NOTE!
For reasons of hygiene, you should change the water in the water container
every 24 hours. If you are not using the device, drain the water from it.
•
If after a longer stoppage you are going to use the device once again, pour fresh
water into the container, carry out 2-3 ice cube making cycles and remove the
produced ice cubes.
6. Cleaning and maintenance
6.1 Safety advice
o
Before beginning with repair or cleaning works make sure the device has been
disconnected from power supply and has cooled down.
o
Do not use any acid agents and make sure no water ingresses the device.
o
To protect yourself from electric shock, never immerse the device, its cables and
the plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets.
Therefore, you must not use any kind of pressure water jet for cleaning the device!
6.2 Cleaning and Descaling
Cleaning
o
Clean the ice cube maker thoroughly after every use and after longer periods of
non-use.
o
Disconnect the ice cube maker from its power source (remove the plug!)
o
Remove the ice cube container and wash it in running water.
o
Clean the interior and exterior of the unit with warm water and a soft cloth.
o
Use soft cloth only and make sure you never use any kind of abrasive agents,
which could scratch the surface.
o
Do not use any petrol products to not damage the plastic parts and the operating
panel.
o
After the cleaning procedure you should use a soft and dry cloth to wipe dry and
polish the surface.
