Bartscher Aurora 22, Инструкция по эксплуатации

Страница: 34 / 84

- 30 -
o
Insert the filter basket by sliding it along the appropriate guides (without coffee).
o
Place the empty glass jug on the lower hot plate under the filter basket.
o
Turn the device on as for normal use.
o
After several drops of the solution have flowed into the glass jug, turn the coffee
machine off.
o
Wait 5-6 minutes for the remainder of the solution to dissolve the deposits, then turn
the device on again.
o
After the entire solution has flowed through the machine, turn the coffee machine
with the toggle switch ON/OFF off and dispose of the solution.
o
After finishing the deposit removal process it is necessary to repeat the brewing
process 2-3 times using only water, in accordance with the instructions for use.
Water remaining in the coffee machine must then be removed with the help of the
flow valve located on the rear wall (at the bottom) of the device.
o
Rinse the glass jug several times with warm water.
o
The device is now ready to resume making coffee.
o
After the calcium deposit removal process it is necessary to carefully wash hands.
WARNING!
During the calcium deposit removal process you must not leave the coffee
machine unattended!
It is necessary to wear protective gloves and goggles while performing the
calcium deposit removal process!
Cleaning the glass jug
Hard water may leave white, mineral residues inside the glass jug. The coffee itself
normally discolors these residues and leaves brown marks. In order to remove these
residues follow the steps below:
1. Take a half-and-half solution of water and vinegar.
2. Leave this solution in the glass jug for about 20 minutes and pour it out afterwards.
3. Rinse the glass jug thoroughly and wipe it dry using a dry, soft cloth. Do not use any
kind of abrasive agents as this could cause scratches which could again result in
cracks.