Installation and operation
16 / 22
272107
EN
Power supply connection
• Verify if technical data of the appliance (see rating plate) correspond with the
local electric power grid specification.
• Connect the appliance to a single, properly grounded mains socket with
protective contact. Do not connect the appliance to a multi-socket.
• The power cord should be laid in a way preventing anyone from threading on it
or tripping against it.
• The appliance is supplied with a connection cable without a plug.
• It is of utmost necessity to install proper disconnector of all poles upstream of
the appliance, so that
— when needed — the appliance is quickly disconnected
from power supply.
• Moreover, establish a correct grounding connection, according to safety
regulations pertaining to electrical installation.
5.2
Operation
•
Prior t o firs t operation, cl ean the appli anc e and its equi pment ac cor ding t o i nstr ucti ons in
sect ion 6 'Cl eaning'
. Make sur e no water enters el ectric i nst allation and connec tion box. T hen thoroughl y dr y the appli anc e and t he entire eq uipment.
•
Ins ert t he bott om c over int o the applianc e. The c over acts as a spac er bet ween t he heating element and l ef t-over f ood tray.
•
Caref ull y i nser t t he c onnection box wit h the heati ng element at t he bac k edge of t he applianc e. A pin in bott om par t of t he c onnecti on box must ent er a hol e i n t he mai n applianc e. This way t he connec tion box is properly mount ed.
Preparation of the Appliance
1. Before use, clean the appliance, observing instructions in section 6
'Cleaning'
.
2. Dry the appliance thoroughly.
Operation of the Appliance
The extractor hood is switched on by the exhaust air installation. Vapours are
vented during preparation of food and exhausted by the exhaust air installation.
1. Plug the LED lighting into a suitable single socket.
2. If needed, switch the LED lighting on, using the installed disconnector.
Switching LED Lighting On
1. If the appliance is not being used, switch the LED lighting off, using the installed
disconnector.