- 21 -
5. The filter may be changed by disconnecting the hoses on the water inlet (IN) and outlet
(OUT) or quick-fit connectors.
a) Replacement by disconnecting the hoses on the water inlet (IN) and
outlet (OUT):
Disconnect the hoses on the water inlet (IN) and outlet (OUT).
Replace the filter.
Install a new mounting bracket to replace the old one. During the installation,
observe the mounting dimensions and hose bending radius.
o
Close the shut-off valve on the water supply hose (IN), to prevent drainage
of water.
o
The water from the hose connected to the water outlet (OUT) should be
drained to the appropriate container (e.g. bucket).
o
Open the water supply to the filter and flush the system until the water
starts flowing evenly without air bubbles.
o
Close the shut-off valve.
Connect the hose to the water outlet (OUT), and connect the other end of the
hose to the terminal unit.
b) Replacement of the filter with quick-fit connectors (see illustrations below):
(1) filter ready for replacement;
(2) prize the blockade open by means of the screwdriver;
(3) remove the blockade;
(4) remove the quick-fit connector from the filter;
(5) repeat the operation on the other quick-fit connector;
(6) inspect the connectors for damages and contaminations, clean or
replace if necessary. Install a new filter.
(7) Mount the blockades in the appropriate places;
(8) Lock the quick-fit connector with the blockades;
