INSTRUCTION MANUAL FOR DISHWASHERS
Page 6 of 12
GB
For versions with rotating basket:
x
If possible, run the cycle only with the basket full,
evenly distributing the dishes.
x
Place the lightest dishes near the middle of the rack,
and the heaviest ones near the outside.
x
Place the smallest dishes near the middle of the rack,
and the largest ones near the outside.
x
Load rack into dishwasher and shut the door.
x
For versions with rotating basket,
make sure the basket turns freely, lightly spinning it
clockwise, then close the door and start the cycle.
x
In order to avoid damages, only load items approved for dishwashing.
x
Do not place silver and stainless steel cutlery in the same basket. This may corrode the steel
and cause the silver to burnish.
On appliances featuring different washing times, select
the appropriate time for the loaded items by using the
“time selection” knob shown here.
START
x
To start the cycle, press the “start” button shown.
x
If available, the “cycle warning light” lights up to
indicate that the cycle has started.
x
After the washing portion of the cycle is terminated,
the appliance automatically initiates the rinse and
discharge operations. At the end of the cycle, the
warning light turns off.
x
If during the cycle the door is accidentally opened, the appliance will automatically stop. To
resume the cycle, simply shut the door.
x
For a quick drying, immediately remove the rack from the dishwasher, once the cycle is
terminated.
x
If the washing solution is found to be excessively dirty or dirt residues are spotted on the
tank filter, carry out the standard maintenance operations as described in the
“Maintenance” chapter.
x
To perform other cycles, repeat the operations listed in the “Washing cycle” paragraph.
4.5
Turning Off the Appliance
Press the “On/off” button as shown. If present, the
corresponding warning light will turn off.
