- 29 -
•
Fitting the mixing bowl
With the mixing bowl cradle lowered, place the chosen mixing tool in the mixing bowl
and position the mixing bowl on the cradle.
There are three location points for the mixing bowl:
a) the locking pin at the rear of the mixing bowl locates in the hole in the cradle;
b) the two weld clips in the mixing bowl handles which engage on the pins
located on the cradle;
c) The mixing bowl locking latches on the right and on the left side.
ATTENTION!
Ensure that the mixing bowl is seated correctly on the cradle before securing the
mixing bowl locking latches prior to use!
•
Fitting the mixing tool
Slide the bayonet fitting of the tool onto the drive shaft
and twist clockwise to secure it in position.
ATTENTION!
Make sure that the mixing tool isfirmly seated in the
drive shaft.
To remove the mixing tool, slide the tool up the shaft
slightly and twist counter clockwise.
•
Speed selection
ATTENTION!
When changing the speed, always turn the device off first, select the new speed
stage and then restart.
Always follow the instructions on the side of the machine when changing gear.
Operating the gearshift during operation results in wear and damage of the gear
unit. In this case any warranty is excluded.
The device is equipped with 3 speed levels. The gearshift for the speed levels is located
on the right side of the device.
The necessary speed can then be selected before restarting the machine by pressing
the START-button.
