10. DIP-SWITCHES
ONLY FOR UNENCAPSULED MODEL
66000361
The selected Network and the Master
mode are set with a small 4-DIP switch on
top of the PCB.
Important: Please do not touch any of the
electronic components, because of the risk
of damage by electrostatic discharge. We
recommend using a small non-conducting
tool to change the DIP switches.
Important: Any changes of the DIP swit-
ches become active after a reset or power
on only!
12. DIP-SWITCH-CONFIGURATION
NOTE:
THE MENTIONED DIP SWITCHES REFER
ONLY TO THE UNENCAPSULED MODEL
66000361!
11. TECHNICAL DATA
Power supply:
Power supply:
7.5 - 26 volt (+ 5 %), regulated. Important:
The power supply should have an equi-
valent pulse load. Unregulated or weak
power supplies may cause flickering or
malfunctions.
Module current (without LED lamps):
ca.- 20 mA
Operating temperature:
0 °C - max. + 50 °C (recommended: <= 30
°C) (Use only in dry places with sufficient
air ventilation)
Radio frequency:
868.3 MHz (licence-free in EC, Switzerland,
Norway and Iceland)
NOTES
Modulation system:
The Chromoflex modules are based on a
digital system, named „Vector-Fractal-Mo-
dulation“ or „VFM“. This modulation sys-
tem was optimised for minimising load on
power supplies and has considerable ad-
vantages compared to traditional systems.
The modulation frequency is in the range
from 120 Hz up to (max.) 240 Hz. Patent
pending.
Model „Chromoflex RC Mini Stripe“
Pulsed constant voltage, maximum cur-
rent allowed: 2 ampere per channel (3
channels)
CONTACT
Josef Barthelme GmbH & Co. KG
Oedenberger Str. 149
90491 Nuremberg | Germany
T: +49 911 42 476 0
E: [email protected]
www.barthelme.de
SUBJECT TO TECHNICAL
CHANGES.
VERSION 06|2016
