4
Rev. 1.0 (04.2020)
Proper use
Intended purpose.
The micropump is intended for pumping liquids or gases with varying flow rates controlled by the electronics. The
controllers are intended for operating the micropumps. Any other use of the micropump or controller unit is
deemed improper.
Do not make any modifications or extensions to the pump or controller without the prior written consent of the
manufacturer. Such modifications may impair the safety of the unit and are prohibited! Bartels Mikrotechnik GmbH
rejects any responsibility for damage to the unit caused by unauthorized modifications to the pump and risk and
liability are automatically transferred to the operator.
Misuse.
The use of liquids, which may alone or in combination create explosive or otherwise health-endangering conditions
(including vapors) is not permitted.
Staff selection and qualification.
All work in connection with the installation, assembly, commissioning/decommissioning, disassembly, operation,
servicing, cleaning and repairing of the pump and the controller must be carried out by qualified, suitably trained
and instructed personnel. Work on electrical components and assemblies must be carried out by personnel with the
necessary qualifications and skills.
About this operating manual.
Warnings and important notes are clearly identified as such in the text. The relevant text sections feature a specific
sign. However, this icon cannot replace the safety instructions. Therefore, carefully read all safety instructions in
this manual. Warnings and important notes in this text are highlighted as shown below, according to the severity
of the damage that might result from non-compliance.
DANGER
DANGER indicates a hazard with a high level of RISK THAT, if not avoided, will result in death or serious injury.
The mp6-XEVA evaluation board
The evaluation board enables the simple use of one micropump of the mp6-series based on the mp6-XOEM
controller. Next to present standard parameter (250 Vpp, 200 Hz) the mp6-XEVA also allows to adjust the pump
parameters, partly by external tuning. As the supply voltage of the module can be provided via USB (no data
interface), just attach it to a USB power supply and start the evaluation. Alternatively, it can also be supplied by a
2.5
–
5 V power supply.
