BSM1402 MASONRY SAW
OI
– B19042
OWNER
’S MANUAL
21
7. The square face closest to the blade should be parallel to the blade. If it is not, raise/lower
both flat rollers until it is level.
8. The table should now be level and square with the blade. If it is not repeat previous steps 2
thru 7.
9. Mount the table to the guide rails and remember to reattach and tighten all hardware.
ELECTRICAL SPECIFICATIONS
RECOMMENDATIONS
•
It is recommended that a 20 amp circuit be used while
operating this saw. This will prevent any loss of power
or interruption.
•
Always plug saw as close as possible to the power
source while operating. This will allow you to receive
optimum electricity.
BSM1402
Pow er
2 HP
Volts
115-120V
Amps
18.3A
Motor RPM
3420 RPM
Cycle
60 Hz
Phase
1
figure 13
Square
