Bartell Global Innovatech Terminator T-2200PRO, Полное руководство

Страница: 13 / 50

P a g e | 12
OIPB-I03026-T2200PRO_v3.1
11. Uncrating and Preparing the Terminator
®
for Operation
When you receive the Terminator
®
, inspect the outside of the crate completely, to detect
damage to the crate itself. If it is damaged, notify the carrier immediately and follow his/her
instructions to file a claim.
Carefully uncrate the machine and inspect it for damage that may have occurred during
shipping. If the shipment is damaged, notify the carrier immediately and file a claim in the
normal manner.
Check packing slip for complete shipment. If shipment is incomplete, notify our Customer
Service Department within 24 hours.
Remove the crate debris, set aside the blades and other packages, and prepare the
Terminator
®
for operation:
CAUTION! If using conventional non-AGM lead acid batteries, wear acid-resistant gloves
and safety glasses and use extreme care when checking battery water levels.
1. To remove the Terminator
®
from a crate with a forklift:
1. Forklift slots have been provided on the sides of the Terminator
®
for moving the
terminator with a forklift.
2. To remove the Terminator
®
from a crate without a forklift:
1.
Turn the Battery Disconnect to the “On” position.
2.
Take 2 x 4’s off the edge of the crate and between the wheels.
3.
Place 2 x 4’s behind the crate of the rear of the machine.
4.
Make a ramp with the 2 x 4’s and the crate material.
5. To start the Terminator
®
, turn the key.
6. Raise the front wheel 5 inches by using the jaw adjustment slider on the joystick.
7. Pull back both joysticks evenly. The machine will start moving slowly.
8. Ensure that both rear wheels come off the crate evenly. Failure to back off evenly
could result in the machine tipping over and harm to the operator.
9. As the machine moves back, ensure that the center wheel clears the crate. If the
center wheel does not clear the crate, raise the machine until the wheel clears.
10. Once the machine is on the ramp, slide it all the way to the bottom, then raise the
jaw assembly up and set the center wheel down on the ground.
12. Loading/Unloading Procedures
• Do not load or unload the Terminator
®
on uneven ground.
• Ensure ramps into moving vehicles are stable and square to the ground.
• Always turn off the Terminator
®
before transporting it.
• Load and unload the machine with a properly weighted forklift or lift-gate.
• Make sure all safety stops are installed on a lift-gate before loading or unloading.
• Never position yourself under/around the machine while moving it with other machinery.
• Park the machine with the jaw completely down after loading.
Discount-Equipment.com