Manual MODUL 200
®
- 11 -
CONTEC
Maschinenbau
& Entwicklungstechnik GmbH
© CONTEC
®
2016
Hauptstrasse 146, 57518 Alsdorf (Sieg) / Germany
Tel: +49 (0) 2741 9344-0 Fax: +49 (0) 2741 9344-29
7 The modular system
7.1
Connecting MODUL 200
®
EU to MODUL 200
®
In the following the connection of a MODUL 200
®
EU to a MODUL 200
®
basic unit is described. It is
assumed, that the control panel for a double unit has already been prepared.
Remove the left side cover (Appendix diagram No. 71) of MODUL 200
®
. Now remove the left side linings of
the blast chamber (Appendix diagram No. 1) and the reclaim chamber (Appendix diagram No. 9). Above the
left side cover is another cover (Appendix diagram No. 153) for the shot compartment, remove this also.
Remove the back skirt (Appendix diagram No. 199 to 205) and the rubber sealing (Appendix diagram No. 83)
of the magnetic frame.
Place the MODUL 200
®
carefully on its right side. Taking care not to damage the shot valve lever or the
remote-control cable.
Remove the upper rear wheel (Appendix diagram No. 189). Place the level adjustment connector in the now
empty axle of the rear wheel system.
Insert the clutch for the shot valves into the shot valve axle (Ap. diagram No. 133).
Place the separating linings (thickness 15 mm) for the reclaim and blast chamber in the position of the removed
side linings.
Place the MODUL 200
®
EU carefully on MODUL 200
®
. Make sure that the level adjustment connector of the
rear wheel is connected to both machines and that the position of the separating linings is correct.
Without the aid of power tools, hand screw both units together and connect the side cover to MODUL 200
®
EU. Now connect the rear wheel to MODUL 200
®
EU. Return the machine to the normal upright position then
screw first the side cover and then both units tight together. Connect the shot compartment side cover to
MODUL 200
®
EU
Lift the control panel and remove the shot compartment lids (Appendix diagram No. 159 to 163). Align the
valve (Appendix diagram No. 129) of MODUL 200
®
EU to the same position of the MODUL 200
®
valve. To
align the valves correctly loosen the screws of the shot valves and place them in the same position. Pull the
clutch on both valve axles and secure them.
Connect the double back skirt to both units. Connect the rubber seals to the magnetic frames.
Loosen the cable protector on the right side of the machine and insert the cable of the MODUL 200
®
EU
turbine motor inside. Connect the plug of the cable to the socket on the control panel.
7.2
Additional and interchangeable parts for the extension of MODUL 200
®
Additional parts:
Clutch for the shot valves
Connection pin for the rear wheel swing
Interchangeable parts:
Back skirt
Rubber sealing for the magnetic frame
Separating linings
Содержание CONTEC MODUL 200
Страница 1: ...MODUL 200 Mobile Shotblaster Instruction manual...
Страница 24: ......