Installation Instruction
Xbeam LTE EX Antenna
BARTEC
TECHNOR AS
Vestre Svanholmen 24
4313 SANDNES
NORWAY
Tel.: +47 51 844100
Fax: +47 51 844101
[email protected]
www.bartec-technor.no
Reservation
Technical data subject to change without notice. Changes, errors and
misprints may not be used as a basis for any claim for damages.
EN 3/4
24
05
2-
5
v1
In
st
al
la
tio
n
In
st
ru
ct
io
ns
X
b
ea
m
L
T
E
E
X
Enclosure material
Seawater resistant anodized Aluminium and
POM.
Max. input voltage
20 Vpp (peak to peak)
Max. input power
IIC = 2 W, IIB = 3,5 W, IIA = 6 W
Impedance
50 Ω
Coax Cable Types
Contact Bartec Technor for further info
Transport, Storage
Damage to the control panel through incor-
rect transport or incorrect storage.
Transport and storage are permissible in
original packaging only.
Assembly / Disassembly
Risk of injury due to incorrect proceedings.
When installing and operating Ex equip-
ment, take care of the applicable safety
standards and generally known electrical
safety standards.
WARNING – POTENTIAL
ELECTROSTATIC CHARGING HAZARD.
Important Note:
The
Xbeam LTE EX
Antenna cannot be
opened and has no physical wiring termi-
nals. The Coax Cable that must be properly
protected and the connection must be car-
ried out in an appropriate certified Ex-e or
Ex-d enclosure or in safe area. Additional
clamping of cable shall be installed to en-
sure that pulling and twisting is not trans-
ferred to the terminations inside the
antenna.
Mounting and Installation
Mounting
The
Xbeam LTE EX
Antenna shall be mounted
as a free standing component with a flying lead
Coax Cable. It shall be mounted using the dedi-
cated fixing holes, 4 off Ø11, in the base of the
antenna. It may be mounted in any orientation.
The fixing bolts must have a length of minimum
35 mm.
Fig 1. Fixing holes for the
Xbeam LTE EX
An-
tenna (all dimensions in mm).
Fig 2. Physical dimensions of the
Xbeam LTE
EX
Antenna (approx. dimensions in mm).
Installation
Find an appropriate installation point where
the radio waves can most freely reach and
be transmitted from the antenna:
On a rigid surface:
Use the four Ø11 mm holes on the baset of
the antenna and fix the antenna to a rigid
surface.
Connect a ≥ 4 mm2 PE wire for equipoten-
tial bonding from the M5 earth bolt on the
antenna base to ground. A corrosion re-
sistant Crimp Ring Terminal, Ø5, and with a
cross section that equals the PE wire must
be used.
Clamp the Coax Cable securely so that the
Coax Cable is without tension as it enters
the antenna and to avoid any pulling and
twisting of the Coax Cable
.
Connect the Coax Cable in an appropriate
certified Ex-e or Ex-d enclosure or in safe
area.
