Bartec BCS 3608ex-NI, Руководство пользователя

Страница: 66 / 76

11 Faults – causes and
remedies
Handscanners
BCS 3600
ex
series
64 / 72
Subject to technical modifications
17/05/18
Fault Possible cause Solution
Cradle has lost the connection
to the host Restore the connection between the
hand-held scanner and cradle (see
Chapter 11.1, P. 65).
Host displays the scanned data
incorrectly Hand-held scanner has not
been configured for
communication with the host Configure the hand-held scanner for the
host type.
Hand-held scanner emits the
following sequence of beeps:
short low, short medium, short
high (switch-on process) With power supply via USB, the
hand-held scanner is repeatedly
switched on and off No action. Normal when the host is reset.
Hand-held scanner emits 4
short high beeps while
decoding a barcode USB initialisation has not been
completed Wait a few seconds then start the scan
process again.
Hand-held scanner emits the
following sequence of beeps:
3 low beeps, 1 very low beep Receive error during
communication via RS-232 Normal when the host is reset.
The hand-held scanner emits
the following sequence of
beeps when changing the USB
connection: short low, short
medium, short high (switch-on
process) Power transmission via USB is
being restored No action. Normal when changing the
USB connection.
Hand-held scanner emits beeps
at regular intervals Wrong interface cable is being
used 1. Check the interface cable.
2. If the wrong interface cable is being
used: connect the correct interface
cable.
Interface cable or mains cable
is loose 1. Check cable connections.
2. Connect loosely connected cables
correctly.
Tab. 30: Faults and troubleshooting