Bartec 6727-61, Инструкция по эксплуатации, Страница: 17 / 27

Operation
4-3
Desk reader for barcode bottles type 6727-61 BA 021212
4.2 Configuration (initialization) for devices with
RS 232 interface
1. Attach the two following barcode tags to a milk sample bottle.
You can copy sheet 1 in the appendix, cut out the tags and stick them to the bottle.
2. Disconnect the device from its power supply for 5-10 seconds by pulling out the power supply
plug of the device for a short time and then plugging it in again.
3. Put both of the bottles with the configuration tags successively into the shaft.
The barcode has to be read. The device acknowledges this with acoustic signals.
4. Connect the device to a PC, unless it has already been connected.
5. Call a terminal program at the PC, e.g. Hyperterminal.
Configure the terminal program:
Regulate COM interface that the interface is plugged into (mostly COM1 or COM2).
Configure interface parameters (9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking).
6. Enter the following character string (Reset):
$+$* [Enter]
7. Wait for a short time until the device has acknowledged the command with an acoustic signal.
8. Enter the following character string (barcode configuration):
$+AZ0AC111010$- [Enter]
9. Wait for a short time until the device has acknowledged the command with an acoustic signal.
10. Take the bottle with the configurations tag out of the device.
The configuration is completed now.
11. For testing, put a “normal“ milk sample bottle into the device. The barcode should be read and
displayed on the screen now.