6
7
FUNCTIONS AND INDICATORS
QUICK LOOK AT THE DETECTOR
1. ELIMINATOR—rotate the control clockwise away from ALL METAL to get DISC
mode. The DISC mode comes with auto ground balance. Rotate the control slowly
and clockwise to eliminate different trash objects.
Rotate the control counter clockwise to the end to get ALL METAL mode. All
METAL also comes with auto ground balance. It’s used to find not only ferrous
metal, but also non-ferrous one (see more details below).
2. SENS—rotate the control counter clockwise to the end to power off the device.
Rotate the control clockwise to power on the device. Continue rotating it clockwise
to get higher sensitivity.
3. VOLUME—rotate the control clockwise to get higher level or to get lower volume
level by rotating it counter clockwise.
4. LOW BATT—Low battery indicator. When LOW BATT indicator lights, user should
replace the batteries.
5. HEADPHONE—3.5mm headphones jack for connecting headphones.
6. View meter—when detector finds any metal target, the meter pointer swings to
the right.
TESTING AND USING THE DETECTOR
This metal detector has two operation modes: ALL METAL & DISC.
ALL METAL - is used to find all kinds of metal targets.
DISC - Is used to discriminate the metal type.
1. To set the operation mode to ALL METAL: turn SENS knob to high position and
turn ELIMINATOR knob counter clockwise to MIN level.
2. Then hold the search coil parallel with the ground about .5~2 inches / 1~5cm
above the surface. Sweep the search coil from side to side in an arc line of 2.75
inches / 7cm motion.
3. When the detector detects a buried target, it sounds a tone. Users can make a
visual note of exact spot on the ground where the detector beeps.
4. Stop the search coil directly over this point on the ground. Move the search
coil straight forward away from you and straight back towards you a couple
of times.
5. Repeat steps 3-4 at a right angle to the original search line. Make a mark of “X”.
The target will be directly below the “X” at which the beep occurs.
