background image

 

extinguish when the DEPTH symbol will light, the ellipses indicate the 

 

probable depth or the signal strength at this time.

 

The contents (surface, 2, 4, 6, 8) inside the five ellipses are just visual 

 

levels for reference.

 Note:
 

- If the detecting pauses for about 5 seconds, the arrow will disappear.

 

- If an arrow points to a coin denomination, the detector might be 

 

  detecting either a coin or another type of metal (such as jewelry, 

 

  tokens, medals, or even junk metal) of similar size and type to the coin.

 

- Since the indications are approximations, the detector is only a visual 

 

  reference to help you decide if an item is worth investigating.

GOLD Range

Iron Foil

Target is probably iron or foil. Some oxidized 

iron might register somewhere within the 

SILVER range.

5¢ or Nickel Target is probably 5¢ or a nickel. Some small 

gold rings might register within this range.

Pull Tab

Target is probably a pull tab of an aluminium 

can. Some small gold rings might register 

within this range might register within PULL 

TAB category.

S-Caps

Target is probably a type of metal like bottle 

cap with whorl. Some medium sized gold rings 

might register within this category.

1¢ or Penny

Target might be a zinc penny or a copper coin. 

Some large rough gold items might register 

within 1¢ category.

SILVER Range 1¢ Penny or

25¢ Quarter

Target is probably silver coin, 25¢ or 1¢. Some 

large aluminium coin might register within 1¢ 

25¢ category.

TONES

 

If the detector is set to the ALL METAL target mode, it sounds a single 

 

tone when it detects any type of metal. If you set the detector to the 

 

DISC or NOTCH modes, the built in audio identification system 

 

sounds a unique audio tone for each of three categories of metal. This 

 

makes it easier to identify the metal being detected.

Tone

Detects

Low Tone

Foil, nails, bottle caps and/or nickels

Medium Tone

Pull tabs, zinc and/or copper items

High Tone

Brass and/or silver items

 Note:
 

- When you set the detector to DISC or NOTCH mode, the detector 

 

  sounds a medium or high tone when it detects highly oxidized iron. An 

 

  arrow appears in medium or high tone area.

 

- Depending on the quality, about 15% percent of gold rings cause the 

 

  detector to sound a medium tone.

TOUCH PADS AND CONTROLS

MODE

Allows the operator to switch in 3 operating modes of 

following settings (DISC-ALL METAL-NOTCH-DISC-) 

for personal preferences

SET

Press and hold the SET touch pad to select the SENS 

display symbol or DISC/NOTCH display symbol in LCD.

ACC/REJ

Function in NOTCH mode only, permits acceptance or 

rejection of specific targets to establish discrimination 

notches.

- / +

Used to increase or decrease the sensitivity and the 

range of discrimination.

GND TRAC

Used to track the buried metal target and to be applied 

in ALL-METAL mode only. It must be pressed once 

ALL-METAL mode is selected.

VOL Control and

ON /OFF switch

Functions as Power ON /OFF switch and can be used 

to adjust the sound level.

GND BAL Control:

Used to offset the effect of mineralization in ALL-

METAL mode. Detection should begin with the GND 

BAL knob set to P region.

OPERATION

Turning on the Detector

 

Rotate VOL away from OFF POWER to the desired position. The unit 

 

displays all symbols and Metal Icons on the LCD screen. The detector 

 

sounds low, medium, high tones respectively. About 2 seconds  late, 

 

the detector enters stand-by state, the LCD screen will display DISC,  

6

www.barska.com

7

www.barska.com

Содержание BE11922









Отзывы: