8
9
1. Press “ * * “ and 2 short beeps will be heard
2. Press “158#“ and 2 short beeps will be heard
3. Input “ Current Master Code# ”and 2 short beeps will be heard
4. Press “ 2# “and 2 short beeps will be heard
This Operation will set the safe to Dual user mode and require to put 2 user codes to
open the safe, please test after set up.
If the Dual User Mode didn’t set successfully, the lock will beep 5 times. Please
repeat steps.
OPENING AND LOCKING SAFE WITH USER CODE/ MASTER CODE
Open
Single User Mode (Default Setting)
1. Press
“User Code or Master Code #”
and light stays green for 5 seconds
2. Turn the handle clockwise before the green light turns off
Dual User Mode (Please refer to Setting Single User & Dual User Mode)
1. Press
“1st Code #”
and 2 short beeps will be heard
2. Press
“2nd Code #”
and light stays in green for 5 seconds
3. Turn the handle clockwise before the green light turns off
NOTE: Master code will override Dual User Mode
If the code is correct, the green light will turn on at 5 seconds and you will hear a
“click” sound.
If the code is incorrect, the red light will turn on along with 5 beeps.
Lock
Close the safe door and turn the handle to the locked position
LOCK OUT MODE
If the wrong codes are entered 4 times consecutively, the keypad will not accept any
code for 5 minutes. Lock starts beep continuously during the lock out mode.
WHAT‘S TIME DELAY FEATURE
The time delay lock is a timer designed to prevent the opening of the safe until it
reaches the pre-set time, even if the correct combinations are known.
The feature was originally created to prevent criminals from using a person or
employee who knows the valid combination in order to gain access to the safe.
SETTING TIME DELAY (1-59 minutes time delay)
1. Press “ * * “ and 2 short beeps will be heard
2. Press “159#“ and 2 short beeps will be heard
3. Input “ Current Master Code #” and 2 short beeps will be heard
4. Input ”Desired Delay Time (01-59) #” and 2 short beeps will be heard
01 = 1 minute Time Delay
59 = 59 minutes Time Delay
00 = turn off Time Delay Mode
If the Time Delay feature didn’t set successfully, the lock will beep 5 times. Please
repeat the steps
HOW TO ACTIVATE SAFE IN TIME DELAY MODE
1. Enter any user code or Master Code
2. Once the code is entered, Time Delay Mode will be activated
NOTE: If the safe is set into Dual User Mode, two user codes need to be
entered to activate
3. During the Time Delay period, codes will not be accepted (Master Code either).
When you press any key, the keypad will be no response.
4. Within the last 30 seconds of the Time Delay period, the lock starts “Beep”
continuously and the green light will flash
5. Once the continuous Beeps stop, the safe will unlock for 5 seconds.
6. Turn the handle to open safe
LOW BATTERY WARNING
If you encounter one of the situations below, please change your battery.
• When you input your code, a green light & red light will turn on for around 5
seconds. You will also hear 10 beeps. The safe will probably not unlock when you
get this response.
• When you input your code, a green light will turn on for around 1 second. The safe
will not open when you get this response.
• If your keypad has no response (no beeps; no light)
After the battery is changed, all registered pin codes will remain saved.
