Barry-Wehmiller Thiele Technologies Streamfeeder Reliant 1500, Руководство пользователя

Страница: 16 / 72

10 R
eliant
1500 M
anual
STEP 5:
Repositioning
Insert Guide Tabs
• Cycle the inserter until the gripper arm jaw is approximately 1/2 in.
(12.7 mm) from the hopper plate (leading edge of material exiting
feeder stops here).
• Locate the two insert guide tabs that protrude from under the back
deck plate. Bend these tabs as required (either up or down) until
their top surface is slightly above the bottom of the gripper arm
jaw. The material to be run will rest on these tabs. The bottom of
the gripper arm jaw must pass under the material without making
contact with it.
• As it is important that there be adequate clearance between the
guide tabs surface and the gripper jaw, use a flat, thin rule (or
gauge) to test for clearance. Ideally, with the gripper jaw should be
fully open when testing.
• Center the gauge on the guide tabs and slide the gauge back and
forth on the tabs, making sure the gripper jaw does not touch the
bottom of the gauge. See Figure 9.
Figure 9. Respositioning Guide Tabs and Testing For Clearance
Inserco inserters only:
Remove the two insert guide tabs that protrude
from the back deck plate. Make a bend in each
tab approximately 1-3/8 in. (34.9 mm) from the
tip by placing the tab approximately 1-3/8 in.
(34.9 mm) into the rear guide assembly. Bend
the tab slightly and repeat same for second tab.
Reinstall insert guide tabs to back deck plate.
NO TE
Ruler or
gauge