Barry-Wehmiller Streamfeeder V-710IJ, Руководство пользователя

Страница: 11 / 58

5
V
alue
S
erieS
V-710iJ M
anual
2
Installing the Machine
!
! !
When performing initial installation, always
make sure you turn Off the main power
switch and disconnect all equipment from the
electrical power source. Failure to do so can
expose you to a potential startup and moving
parts which can cause serious injury.
Do not attempt feeder installation while
the feeder and machine of application are
running. Failure to do so can expose you to
moving parts which can cause serious injury.
Do not wear loose clothing when operating the
feeder.
Avoid turning on the feeder or making initial
adjustments until all parts are secured. Failure
to do so can cause damage to equipment.
This section provides information on installing the V-710IJ Universal
Friction Feeder onto a vacuum or non-vacuum transport base.
Information for a particular application typically includes procedures
for basic parts removal, feeder mounting and alignment, and cable
connections for power and control interface. Information that relates
to specific adjustments you must make to feeder prior to startup and
operation is found in Section 3, “Preparing for Operation.”
Vacuum Base
Installation
Installation of the V-710IJ Universal Friction Feeder onto various
types of vacuum and non-vacuum bases is a relatively simple proce -
dure. Several minor modifications to the vacuum base are required
prior to mounting, wiring, and aligning the feeder.
To install the feeder onto a vacuum base, perform the following steps:
1: Repositioning front side guides
2: Removing back jogging plate/back hopper guide
3: Raising hopping rollers
4: Disabling the shuttle
5: Initial positioning of feeder
6: Providing AC power to feeder
7: Connecting external run input
8: Checking material discharge from feeder