Barrus Shire 30 RB, Руководство пользователя, Страница: 31 / 51

RDG603A17 – Issue 1 – Shire 30_40_50 WB/RB Manual
Page 31 of 51
Figure 10: Primary Fuel Filter Drain Screw
7. Primary and Secondary Fuel Filter Change
•
Ensure the fuel tank is at least ¾ full prior to undertaking this procedure.
•
Turn off the main boat fuel supply tap. This is located on or near the fuel tank.
•
Place a small drip tray under the filter body.
•
Remove the fuel filters using the filter strap wrench supplied. Unscrew them until
loose then remove by hand.
•
Primary fuel filter only: Retain the metal fuel filter drain screw from the old filter and
reuse in the new filter. The part number for the drain screw is RDG9189022.
•
Smear a small amount of clean fuel on all of the O ring seals that are supplied with
the new filter element.
•
Screw the new element back into the filter head. Tighten by hand only.
•
Turn the main boat fuel supply tap back on.
•
Ensure the system is correctly bled before attempting to start up.
Note: The same procedure is used for both the primary and secondary fuel filter changes.
8. Fuel System Bleeding
•
Ensure the fuel tank is at least ¾ full prior to undertaking this procedure.
•
See the fuel paragraph in Section 3 of the Yanmar engine operation manual.
9. Cooling System
CAUTION:
DO NOT CHECK THE COOLANT LEVEL WHEN THE ENGINE IS HOT. REMOVE THE
IGNITION KEY BEFORE WORKING IN ENGINE COMPARTMENT.
For All Models