INSTALLATION INSTRUCTIONS
800.533.3948
•
www.barronltg.com
2
40070002 REV 1 10/14
FBTCJ-24V
General Material/Tool Requirements:
1. Measure the installation location to determine product length.
Due to internal circuitry, colors of the FBTCJ have different cutting
increments as listed below:
•
Red - 5” cutting increments
•
Green and Blue - 3” cutting increments
•
All Whites - 3” cutting increments
2. Measure the FBTCJ to match required installation length. Locate
the closest cutting mark on the side. This is designated by
vertical dashed lines. (Fig. 1)
3. Using a hand-held PVC cutter, make an even cut through product
exactly on the dashed line. If cut off the dashed line the product
can be damaged.
NOTE:
It is imperative to use a sharp cutting blade to make a straight cut. Sharp blades will help you avoid
pulling the internal circuitry while making the cut. Stretching or pulling the product can result in damage.
4. Install power connector to the end of the FBTCJ-FC-24V. Be sure to notice the orientation of product and the
power connector. The product has a right and left side. The FBTCJ-FC-24V power connector also has a
Right and Left orientation. To determine look at the cut end of the product and the orientation of the internal circuits;
to the right of center will dictate right power connector will be used, to the left of center will dictate left power
connector will be used.
The above detail indicates all the parts needed for a complete assembly
Material needed for installation:
FBTCJ-24V - Flexible Border Tube
FBTCJ-FC- Front Connector Cable Assembly
FBTCJ-EC - End Cap
FBTCJ-GR - Installation tool
24VDC Transformers
Handheld PVC cutter
Measuring tape
Pliers
Fig.1
1. Front Connector
2. Anti-Skidding Clip
3. Mounting Piece
4. Light
5. Silico Gasket
6. Screws
7. End Cap
6
7 5
3
2
2
3
6
5
1
Fig. 2
