800.533.3948 • www.barronltg.com
2
OPERATING MANUAL
40070012 REV 1 - 11/18
GLB-1000-DE
3.
Instructions for LED Power System Indicator
a. The LED power indicator is on and no blink: Normal operation state.
b. Blink Once: Fan failure or obstruction. Please check for broken fan or object(s) obstructing fan operation.
c. Blink Twice: Under (90VAC) or over voltage (290VAC) protection. Please check your power supply’s stability.
d. Blink Three times: Short or open circuit protection. Your ballast will attempt to restart after 100 seconds, and it
will automatically shutdown after 20 minutes if the problem continues to occur.
e. Blink Four times: High temperature safety shut down. Your ballast will automatically restart when the internal
temperature is under 55ºC (131°F).
4.
Specifications
a. Switchable Methods: Manual knob.
b. Switchable Settings: 400W-600W-1000W-DE Double Ended.
c. Input Voltage: 90~305V (8.6A@120V - 4.1A@240V - 3.8A@277V)
d. Strike Voltage: ≥3.5kV
e. Built in fan cooling, quiet operation.
f. Size: L15.20”x W4.41”x H2.76”.
5.
Notes
a. Switching power supply voltage. If you use a voltage regulator or transformer, please switch power supply slowly.
If you want to change 120V to 240V or 277V quickly, please unplug 120V cord, and then plug into 240V or 277V
power receptacle
b. If you fail to comply, the Digital Electronic Ballast could fail and warranty will be voided
6.
Safety
a. Do not alter or modify the Digital Electronic Ballast in any way. It may cause bodily injury or death as this is
a high power electrical device.
b. Do not submerse in water or splash water on the unit.
d. Do not plug or unplug the lamp cord while the Digital Electronic Ballast is plugged into power supply.
e. Failure to observe the following safety warnings may result in serious injury or death.
f. Failure to observe these safety warnings will result in a waiver of all liabilities and will void all warranty.
g. The use of output splitters for the purpose of running two lamps on a single ballast is NOT recommended and will
void the manufacturer warranty.
7.
Warnings
a. Do not connect input and output together; the lighting fixture should be grounded correctly through the power
connection; Improper wiring of output connection will permanently damage the ballast.
b. If the exterior of the lamp is damaged, don't attempt to use, replace lamp immediately.
c. When re-installing lamp, make sure lamp has time to cool before touching.
d. Make sure power supply and lamp cable are connected properly.
e. Always disconnect power supply before reinstalling the lamp.
f. Do not hang or lift the ballast by the power or the lamp cord.
g.
Do not touch the interior of the socket while power is on.
h. Do not operate electronic ballast in extremely high humidity or damp locations.
i. Do not plug electronic ballast into wrong power supply.
j. Do not attempt to open the casing/housing of the Digital Electronic Ballast, it will void your warranty.
k. Do not put the Electronic Ballast in an airtight environment.
l. Keep away from children.
