400U SERIES
INSTALLATION INSTRUCTIONS
800 533.3948
•
www.barronltg.com
10070143 Rev 1 - 03/14
2
7. Determine the position the exit needs to be mounted
(the way the face needs to be pointed). Use the
included round junction box mounting plate and small
#8-32 screws provide to tighten securely (Fig. E)
8. Remove the proper chevron(s) from the EXIT
legends(s) if necessary. Reattach the ground wire to
the faceplate (Fig. F)
9. Attach battery jumper wire (where applicable) to PC
board and replace face plate back on unit to complete
installation.
FLUSH MOUNTING
1. Remove faceplate cover by pulling equally at the outer
rim of the face plate on two opposite sides. Remove
ground wire from face plate (Fig. F)
2. Remove desired knockout on baseplate and mount to junction box using hardware supplied with junction box.
3. Route wires through the center knockout.
4. All Electrical connections should be made inside junction box.
Make Electrical Connections as follows:
Note:
Cap unused leads to prevent shorting
5. Remove the proper chevron(s) from the EXIT legends(s) if necessary. Reattach the ground wire to the faceplate
(Fig. F).
6. Attach battery jumper wire (where applicable) to PC board and replace face plate back on the unit to complete
installation.
WIRING DIAGRAMS
Fig. F
Fig. E
Fig. D
120V AC
White - Common
Black -120V
Green - Ground
277V AC
White - Common
Orange - 277V
Green - Ground
