Barrett Jewel, Техническое руководство

Страница: 35 / 44

15.6 Inspection
Each controller acts as a diagnostic system and if a fault is detected the battery gauge will flash
to a pre-determined sequence.
Control Dynamic DL Controller
The three colour illuminated display onthe top surface of the DL Controller acts as both a fuel
gauge and a warning gauge. When all lights are on the batteries are fully charged. As the power
is used the green lights and then amber lights will go out. When only the red lights are left on
the batteries will require recharging. If a fault is detected the illuminated display will flash. To
determine the fault count the number of flashes and refer to the following table:
1 Low battery You may need to charge your batteries
2 High battery Possible charger fault
3 Left Motor There may be a fault or a loose connection
4 Right Motor There may be a fault or a loose connection
5 Left or Right Park Brake There may be a fault or a loose connection
6 Controller fault Please contact Customer Services -
7 Motor stalled or joystick Switch the controller off then back on again
out of neutral/time out
Control Dynamic DX System
The three colour illuminated display on the top surface of the DL Controller acts as both a fuel
gauge and a warning gauge. When all lights are on the batteries are fully charged. As the power
is used the green lights and then amber lights will go out. When only the red lights are left on the
batteries will require recharging. If a fault is detected the illuminated display will flash. To
determine the fault count the number of flashes and refer to the following table:
1 Limp Mode Turn the controller off & then on again
2 Accessory Fault Possible remote joystick fault
3 Left Motor There may be a fault or a loose connection
4 Right Motor There may be a fault or a loose connection
5 Left Park Brake There may be a fault or a loose connection
6 Right Park Brake There may be a fault or a loose connection
7 Low Battery You may need to charge your batteries
8 Over Voltage Check the battery circuit for loose connection
9,10 Limp Mode Turn the controller off & then on again
11 Motor stalled or joystick Switch the controller off then back on again
out of neutral/time out
12 Module Mismatch Check the compatibility of modules.