Use the following measurements to set the rack up correctly and tighten the bolts.
A, B, C = 1055mm
C
B
A
A, B, C = 1055mm
C
B
A, B, C = 1055mm
A
C
B
A
Important:-
Double check the tightness of all the bolts.
Preparing the Vehicle
There are six fitting points on the vehicle, positioned at the front, centre and rear of the roof. The
standard size roof rack uses all six points.
Locate the hooks on the inner side of the rubber strips on the roof. There are three hooks per side.
The roof rack clamp has a slot at the bottom which the hook passes through. Make sure the hook is
the correct way round. Temporarily hold the clamp in an upright position with the masking tape as
shown in the following diagram, so the rack can be placed on the roof top without interference.
Tape
Vehicle
Clamp
Rubber Strip
Tape
Vehicle
Clamp
Rubber Strip
18 of 31
