9
BD-2003 CORE SAW
SAFETY
MAINTENANCE SAFETY
•
NEVER
lubricate components or attempt service on a running machine.
•
Keep the machinery in proper running condition.
Clean the machine after each day’s use. Follow
instructions for changing accessories. Inspect tool periodically and, if damaged, have repaired by
authorized service facility.
ELECTRICAL SAFETY
SET UP & TRANSPORTATION SAFETY
• ALWAYS
use caution and follow the instructions when lifting and transporting this machine.
• ALWAYS
tie down the machine when transporting.
DO NOT
tow this machine behind a vehicle.
• NEVER
transport with the blade mounted on the machine.
•
Lift only from the lift bail.
•
Make sure the OFF/ON power switch on the electric motor is always in the
OFF
position before
inserting the machine’s power plug into an AC receptacle.
•
Operate electric motor only at the specified voltage indicated on
the nameplate.
• ALWAYS
make sure electric powered machines are plugged into a properly grounded circuit.
DO
NOT
replace the motor with any motor that does not have a special grounding connection.
• DO
follow all electrical codes in your area.
ALWAYS
check for buried electrical cables before
sawing. If unsure, contact the local utilities.
•
ALWAYS
disconnect AC power plug from power source before moving or servicing the machine.
• NEVER
disconnect any “emergency or safety devices.” These devices are intended for operator
safety. Disconnection of these devices can cause severe injury, bodily harm or even death!
Disconnection of any of these devices will void all warranties.
•
Unauthorized equipment modifications will void all warranties. Manufacturer does not assume
responsibility for any accident due to equipment modifications.
• NEVER
use accessories or attachments, which are not recommended by Barranca Diamond for
this equipment. Damage to the equipment and/or injury to user may result.
•
Make sure power cords are the proper size and in good condition.
DO NOT
allow a
power cord to become damaged.
NEVER
allow the power cord to come into contact with water,
fluids, heat, oil or sharp edges.
ALWAYS
ensure that the electrical extension cord is not
trapped underneath the machine.
