8
•
ALWAYS
cut in a straight line.
DO NOT
cut deeper than 1” per pass with a dry blade. Step cut to
achieve deeper cuts.
NEVER
force, jam, wedge or twist the blade in a cut.
DO NOT
grind on the
side of the blade.
•
DO NOT
touch a dry cutting blade immediately after use. These blades require several minutes to
cool after each cut.
DO NOT
use a blade that has been overheated (Core has a bluish color).
• NEVER
stand on the tool. Serious injury could occur if a power tool is tipped, or if a cutting tool
is unintentionally contacted.
•
Become familiar with the controls of the machine before operating. Know how to stop the
machine quickly in case of emergency.
• ALWAYS
secure work. Clamps or a vise should be used to hold work whenever practical.
Keeping your hands free to operate a power tool is safer.
• ALWAYS
disconnect AC power plug from power source before moving, cleaning or servicing
the machine.
• NEVER
leave a tool running unattended. Do not leave a tool until it comes to a complete stop.
ALWAYS
turn a power tool
OFF
when leaving the work area, or when a cut is finished.
•
Make sure the OFF/ON power switch on the electric motor is always in the
OFF
position before
inserting the machine’s power plug into an AC receptacle.
•
Operate electric motor only at the specified voltage indicated on the nameplate.
• NEVER
disconnect any “emergency or safety devices.” These devices are intended for
operator safety. Disconnection of these devices can cause severe injury, bodily harm or even
death! Disconnection of any of these devices will void all warranties.
•
Unauthorized equipment modifications will void all warranties. Manufacturer does not assume
responsibility for any accident due to equipment modifications.
• NEVER
use accessories or attachments, which are not recommended by MK Diamond for this
equipment. Damage to the equipment and/or injury to user may result.
•
Replace damaged cutting blade before operating.
• NEVER
try to stop a moving blade with your hand.
MOTOR OVERLOAD SAFETY
•
If the machine goes off unexpectedly, the motor’s overload cutout may have been
activated. In this case, unplug the machine from the power supply and wait until the
motor and overload cutout have cooled down.
(
(
)
)
BD-2003 CORE SAW
SAFETY
