Baroness LM66GC, Руководство по эксплуатации для владельца, Страница: 60 / 85

Insert one or two strips of newspaper into the
space between the reel cutter (cutting
cylinder) and the bed knife (bottom blade) at
an angle of 90 degrees. Then, rotate the reel
cutter (cutting cylinder) counter-clockwise
(when you face the mower unit from the left)
to check the sharpness of the blades.
1
A
2
zhz6po-005
Back Lapping of Reel Cutter (Cutting Cylinder)_003
1 Reel cutter (Cutting cylinder)
2 Bed knife (bottom blade)
A Rotation direction
Check the sharpness of the entire range
(three or four points from the left edge to the
right one) of the reel cutter (cutting cylinder).
With a piece of chalk, etc., mark locations on
the blade that are sharp.
With a roller receiver, jack stand, etc.,
position the machine so that the bed knife
(bottom blade) is level.
1
2
zhz6po-006
Back Lapping of Reel Cutter (Cutting Cylinder)_004
1 Roller receiver
2 Lapping machine
5.
6.
7.
8.
Connect the lapping machine or lapping
handle to the lapping bolt of the machine.
1
zhz6po-007
Back Lapping of Reel Cutter (Cutting Cylinder)_005
1 Lapping bolt
Rotate the reel cutter (cutting cylinder)
clockwise (reverse rotation) when you face
the mower unit from the left.
Turn on the lapping machine.
Otherwise, rotate the lapping handle.
Important
The right side of the reel cutter (cutting
cylinder) (when you face the mower unit from
the front) is inclined to wear earlier than the
left side. Accordingly be sure to move the
brush from the left to the right to apply the
abrasive.
zhz6po-008
Back Lapping of Reel Cutter (Cutting Cylinder)_006
Apply the abrasive evenly with the brush on
the top side of reel cutter (cutting cylinder)
where the newspaper was cut well or of
chalk-marked locations.
(Never apply to blunt areas.)
Rotate the reel cutter (cutting cylinder) for a
while and stop its rotation when the sound of
contact is lost.
Turn off the lapping machine.
Otherwise, stop rotating the lapping
handle.
9.
10.
･
･
11.
12.
･
･
LM56GC
・
LM66GC / LM66TC
Maintenance
Page 5-10
Maintenance (Mower)