Baroness LM285, Руководство по эксплуатации для владельца, Страница: 59 / 65

Finally, apply the abrasive on the entire
range of the reel cutter (cutting cylinder) and
perform final lapping.
Stop the rotation of the reel cutter (cutting
cylinder), stop the engine, and then wash off
the abrasive using a washer etc.
While checking the blade for sharpness,
adjust blade engagement.
Maintenance (Main Body)
Removing/Installing Tires
Front Tires
Follow the steps below to remove the front
tires:
Loosen the bolts.
1
lm2ieh-002
Front Tires_001
1 Heat-treated bolt
Place the jack beneath the jack-up point of
the front left/right frame area securely, then
raise it until the tire lifts off the ground.
（
(See "Jack-up Points" (Page 5-5) .)
Remove the bolts.
Remove the tire from the wheel mounting
seat.
Caution
Refer to the Tightening Torque table.
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening.
Important
Tighten the bolts in the tightening order
(crosswise).
For installing the front tires, reverse the
removing procedure.
14.
15.
16.
1.
2.
3.
4.
Rear Tires
Follow the steps below to remove the rear
tires:
Loosen the bolts.
1
upekw4-002
Rear Tires_001
1 Heat-treated bolt
Place the jack beneath the jack-up point of
the rear left/right frame area securely, then
raise it until the tire lifts off the ground.
（
(See "Jack-up Points" (Page 5-5) .)
Remove the bolts.
Remove the tire from the wheel mounting
seat.
Caution
Refer to the Tightening Torque table.
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening.
Important
Tighten the bolts in the tightening order
(crosswise).
For installing the rear tires, reverse the
removing procedure.
Adjustment of Belt Tension
Caution
Be sure to stop the engine before adjusting
the belts.
Important
Make sure that the belt has the specified
amount of tension.
1.
2.
3.
4.
Ma
intena
nce
LM285
Maintenance
Page 5-11
Maintenance (Main Body)