Baroness LM285, Руководство по эксплуатации для владельца, Страница: 46 / 65

Pilot Lamps
Charge Lamp
The charge lamp is the left pilot lamp located in
the operation panel.
It turns on when the ignition key is set to the
"ON" position before the engine starts. It turns
off when the engine starts and the alternator
starts operating properly.
If this lamp illuminates while you are operating
the machine, stop the engine immediately, and
then inspect the machine and perform any
necessary maintenance.
1
࠴ࡖ࡯ࠫ ࠨ࡯ࡕࠬ࠲࡯࠻ ࠛࡦࠫࡦᴤ࿶
ifzqmc-001
Charge Lamp_001
1 Charge lamp
Thermo-start Lamp
The thermo-start lamp is the middle pilot lamp
located in the operation panel.
When the ignition key is set to the "GLOW"
position, it illuminates as the glow plug
generates heat.
Illumination of the thermo-start lamp is
controlled by the glow lamp timer, and the lamp
is turned off after a specified amount of time
passes.
The duration of illumination indicates an
approximate period of time required for warm-
up, and has been fixed at five seconds.
1
࠴ࡖ࡯ࠫ ࠨ࡯ࡕࠬ࠲࡯࠻ ࠛࡦࠫࡦᴤ࿶
q44uug-001
Thermo-start Lamp_001
1 Thermo-start lamp
Oil Pressure Lamp
The oil pressure lamp is the right pilot lamp
located in the operation panel.
It turns on when the ignition key is set to the
"ON" position before the engine starts. It turns
off when the engine starts and engine oil
pressure is generated properly.
If this lamp illuminates while you are operating
the machine, stop the engine immediately, and
then inspect the machine and perform any
necessary maintenance.
1
࠴ࡖ࡯ࠫ ࠨ࡯ࡕࠬ࠲࡯࠻ ࠛࡦࠫࡦᴤ࿶
1ldikn-001
Oil Pressure Lamp_001
1 Oil pressure lamp
Angle Meter
The angle meter is located in the upper center of
the operation panel.
This instrument indicates the angle of the
machine position.
Travel of Machine
Moving the Machine
Start the engine.
（
(See "Procedure to Start
Engine" (Page 4-17) .)
Raise all mower units, and set the anti-falling
stop valves to the "Stop" position.
Depress the brake pedal, and while pressing
the push button, return the parking brake
lever to its resting position.
Slowly depress the traveling pedal.
The machine will start to move.
Towing the Machine
If the machine does not travel due to engine
trouble, etc., you can move it in the following
ways:
Pushing by hand
1.
2.
3.
4.
5.
･
LM285
Handling Instructions
Page 4-26
Travel of Machine