Preparation for Use
Installing The Handle
Put the handle pin on the left frame into the
hole at the left-side lower edge of the handle.
While pressing the right-side lower edge of
the handle inward, put the handle pin of the
right frame into the hole.
Secure the lower edges (slotted section of
the handle adjusters) of the right and left
sides of the handle to the rear frame stay
from the back with the bolts, conical spring
washers, and washers.
Step:2
2
5
8
7
6
4
3
1
gifnuq-001
Installing The Handle_001
1
Left-side lower edge of handle
2
Right-side lower edge of handle
3
Handle pin (Right frame)
4
Handle pin (Left frame)
5
Handle adjuster
6
Bolt
7
Conical spring washer
8
Washer
Connection of Engine Switch Cord
Important
When the connection of the engine switch
cord is incomplete, the engine will not stop
even if the engine switch is operated.
Check that the cord is correctly connected.
When assembling the handle, check the
connection of the engine switch cord.
There are two connections - plug and crimp
terminal.
The plug is connected to the plug connected
to the engine.
1.
2.
3.
1.
The crimp terminal is secured to the engine
crankcase with a hexagon bolt.
2
1
eo4kem-002
Connection of Engine Switch Cord_001
1
Plug
2
Crimp terminal
Installing The Stand
With the inside projection side set to the
right, temporarily secure the left side of the
stand to the frame with the bolt, washer
(inside), and nut (outside).
Put the spring on the projection of the frame
and the projection at the right edge of the
stand.
1
5
6
3
2
4
y7fthb-001
Installing The Stand_001
1
Stand
2
Bolt
3
Washer
4
Nut
5
Projection
6
Spring
While pulling the right side of the stand
backward, make alignment with the hole in
the frame, and secure the stand with the
bolt, washer (inside), and nut (outside).
2.
1.
2.
3.
LM18GC
・
LM56GC / LM66TC
Handling Instructions
Page 5-2
Preparation for Use
