Baroness FS900, Руководство по эксплуатации для владельца

Страница: 74 / 95

Change of Rotary Plates
Caution
During maintenance service, raise the empty
bucket.
Important
If the rotary plates are worn, cores will not be
properly collected.
Important
Replace all rotary plates. Otherwise the
weight will become unbalanced and vibration
may occur.
If wear of the rotary plates exceeds 5.0 mm
(0.20 in) or if they are deformed or cracked,
replace the rotary plates.
Move the machine to level ground.
Apply the parking brake.
Raise the bucket to its highest position.
Stop the engine.
Warning
To keep the position of raised bucket, be sure
to lock it with the cylinder lock.
Lock the bucket with the cylinder lock.
Remove the brush cover.
Remove the bolts securing the rotary plate.
1
2
2rp7t3-001
Change of Rotary Plates_001
1 Bolt
2 Rotary plate
Remove the rotary plate.
1.
2.
3.
4.
5.
6.
7.
8.
Install a new rotary plate.
Important
Evenly install the rotary plate.
Adjust the rotary plate so that there is a
clearance of approximately 5.0 mm (0.20 in)
between it and the brush frame, and then
temporarily tighten the bolts.
A
2
1
2rp7t3-002
Change of Rotary Plates_002
1 Rotary Plates
2 Brush frame
A 5.0 mm (0.20 in)
Slowly rotate the rotary plates by hand, and
then follow the same steps to adjust the
remaining rotary plates and temporarily
tighten the bolts.
Slowly rotate the rotary plates by hand,
check the clearance again and tighten the
bolts so that all the clearances between the
rotary plates and the brush frame will be the
same.
After making adjustments of all the rotary
plates and tightening the bolts, tighten all
bolts firmly.
Install the brush cover.
Start the engine, rotate the rotary plates, and
then check that there is no contact between
or vibration in the rotary plates and brush
frame.
9.
10.
11.
12.
13.
14.
15.
FS900
Maintenance
Page 6-14
Adjustment and Replacement